Nanners' Blog My rantings

12Feb/130

Thing-O-Matic Calibration

Last night I did some calibration on the Thing-O-Matic, I was able to print faster than I've ever printed before, and was able to get some petty good detail.  I find that my printer leaves flat areas a bit rougher than I'd like, but then again it might be the plastic.  For some reason I find that the Tardis blue ABS that I've been using seems to come out a bit gooey from the extruder.  I think I'll re-run my gear test prints using a bit lower of a temperature and see what I get.

Comments (0) Trackbacks (0)

No comments yet.


Leave a comment

No trackbacks yet.